Honda Accord 2008 Manual page 1725

07/11/02 09:34:17 61TA0000_200_0158
Dashboard
Dashboard Center Lower Cover Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014
Available through the American Honda Tool and
Equipment Program; call 888-424-6857
SRS components are located in this area. Review the
SRS component locations, 2-door (see page 24-21),
4-door (see page 24-19) and the precautions and
procedures (see page 24-23) before doing repairs or
service.
NOTE:
• Take care not to scratch the dashboard and its related
parts.
• Use the appropriate tool from the KTC trim tool set to
avoid damage when removing components.
1. Remove the center console panel (see page 20-145).
2. Release both front portions of the center console
(A) from the dashboard.
–1 Remove the screws.
–2 Detach the clips by pulling the front bottom
–3 Gently pull up both front portions of the
＊０１
Fastener Locations
: Screw, 2
20-156
edges of the console out from both sides.
console to release the hooks (B) from the
dashboard.
: Clip, 2
3. Remove the driver's dashboard center lower cover
(A).
–1 Remove the clip (B).
–2 Gently pull the rear upper edge of the cover to
detach the clip (C).
–3 Pull up the rear portion of the cover to release
the hook (D) from the rear heater duct (E).
–4 Pull the cover rearward to release the hook (F)
from the heater unit (G).
Fastener Locations
B : Clip, 1
F
B
B
A
ＴＡ０８Ａ００Ｊ２６２２０２１９２８１ＫＤＡＴ１２
C : Clip, 1
E
G
C
B
D
A
＊０２