Honda Accord 2008 Manual page 1728

07/11/02 09:36:07 61TA0000_200_0161
Passenger's Dashboard Trim
Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014
Available through the American Honda Tool and
Equipment Program; call 888-424-6857
NOTE:
• Take care not to scratch the dashboard and its related
parts.
• Use the appropriate tool from the KTC trim tool set to
avoid damage when removing components.
1. Remove the passenger's dashboard trim (A).
–1 Open the glove box.
–2 Pull out on the outside bottom edge of the trim
–3 Detach the clips along the trim.
–4 Release the hook (B) from under the center
＊０３
Fastener Locations
: Clip, 8
C
2. Install the trim in the reverse order of removal, and
note these items:
• If the clips are damaged or stress-whitened,
replace them with new ones.
• First insert the hook under the center panel, then
push the clips into place securely.
ＴＡ０８Ａ００Ｊ２６２２０２１９３６５ＫＤＡＴ３０
by hand.
panel (C).
A
Glove Box Lock Cylinder
Replacement
NOTE: Take care not to scratch the glove box.
1. Remove the glove box (see page 20-160).
2. Lift the glove box handle (A), and use a hook-
shaped tool to pull one end of the retainer (B) out of
its slot.
NOTE: Do not remove the retainer entirely. Leave
one end of the retainer in its original position when
removing the lock cylinder.
A
3. Remove the glove box lock cylinder (A).
B
ＴＡ０８Ａ００Ｊ２６２２０２３０１１５ＫＢＡＴ２０
B
B B
A
(cont'd)
20-159 20-159
＊０１
＊０２