Honda Accord 2008 Manual page 1676

07/11/02 09:32:27 61TA0000_200_0109
Special Tools Required
KTC trim tool set SOJATP2014
Available through the American Honda Tool and
Equipment Program; call 888-424-6857
B-Pillar Upper/Lower Trim - 4-door
SRS components are located in this area. Review the
SRS component locations (see page 24-19) and the
precautions and procedures (see page 24-23) before
doing repairs or service.
NOTE:
• Put on gloves to protect your hands.
• Take care not to bend or scratch the trim and the
panels.
• Use the appropriate tool from the KTC trim tool set to
avoid damage when removing components.
1. Remove these items:
• Front door sill trim (see page 20-99)
• Rear door sill trim (see page 20-100)
• Front door opening seal, as needed (see step 6
on page 20-100)
• Rear door opening seal, as needed (see step 3 on
page 20-101)
2. Slide the front seat forward fully.
3. Remove the B-pillar lower trim (A).
–1 Pull the upper portion of the trim back to
detach the upper hooks (B).
–2 Detach the lower clip by pulling the bottom of
the trim back by hand.
Fastener Location
: Clip, 1
(Gray)
A
4. Remove the front seat belt lower anchor (see page
24-8).
ＴＡ０８ＡＢ４Ｊ２６２７３４０００００ＫＤＡＴ４８
B
A
(cont'd)
20-107
＊０７