Honda Accord 2008 Manual page 1687

07/11/02 09:32:33 61TA0000_200_0120
Interior Trim
Trim Removal/Installation - Rear Side Area
Special Tools Required
KTC trim tool set SOJATP2014
Available through the American Honda Tool and
Equipment Program; call 888-424-6857
2-door
SRS components are located in this area. Review the
SRS component locations (see page 24-21) and the
precautions and procedures (see page 24-23) before
doing repairs or service.
NOTE:
• Put on gloves to protect your hands.
• Take care not to bend or scratch the trim and the
panels.
• Use the appropriate tool from the KTC trim tool set to
avoid damage when removing components.
1. Remove these items:
• Door sill trim (see page 20-97)
• C-pillar trim (see page 20-110)
• Rear seat-back (see page 20-222)
• Rear seat cushion (see page 20-224)
2. Lower the rear seat pivot bracket (A).
＊２４
20-118
A
3. Remove the rear side trim panel (A).
–1 Remove the clip (B).
–2 Gently pull the rear shelf (C) back to release the
projections (D) and detach the hook (E) from
the panel.
–3 Detach the clips (F) by pulling the panel back.
–4 Release the hooks (G) and the tabs (H) from the
B-pillar upper trim (I).
Fastener Locations
B : Clip, 1 F
: Clip, 6
(Gray)
C
A
E
D
C
F
F
F F
F
B
F
A
4. Install the panel in the reverse order of removal,
and note these items:
• If the clips are damaged or stress-whitened,
replace them with new ones.
• Push the clips and the hooks into place securely.
ＴＡ０８ＡＢ２Ｊ２６２７３４０００００ＫＤＡＴ１３
H
I
H
G
A
I
＊２５