Driveshaft Disassembly - Honda Accord 2008 Manual

07/11/02 09:17:11 61TA0000_160_0006
Driveline/Axle
Driveshaft Removal (cont'd)
10. Right driveshaft: Drive the inboard joint (A) off of
the intermediate shaft using a drift and a hammer.
Remove the driveshaft as an assembly.
NOTE: Do not pull on the driveshaft (B), or the
inboard joint may come apart. Pull the driveshaft
straight out to avoid damaging the oil seal.
＊０７
16-6 16-6

Driveshaft Disassembly

Special Tools Required
• Threaded adapter, 26 x 1.5 mm 07XAC-001030A
• Slide hammer, 5/8''-18 UNF, commercially available
• Puller, commercially available
• Boot band pliers, commercially available
Inboard Joint Side
1. Remove the set ring from the inboard joint.
B
A
ＴＡ０８ＡＥ４Ｅ１６２２６６０００００ＬＣＡＴ００
＊０１