Input Shaft (Mainshaft) Speed Sensor Replacement; Output Shaft (Countershaft) Speed Sensor Replacement - Honda Accord 2008 Manual

07/11/02 09:18:12 61TA0000_140_0238
Automatic Transmission
Input Shaft (Mainshaft) Speed
Sensor Replacement
1. Remove the bolts securing the under-hood fuse/
relay box, and swing it out of the way.
2. Remove the intake air duct and the air cleaner
assembly.
3. Disconnect the input shaft (mainshaft) speed
sensor connector, and remove the input shaft
(mainshaft) speed sensor (A).
＊０１
4. Install a new O-ring (B) on a new input shaft
(mainshaft) speed sensor, then install the input
shaft (mainshaft) speed sensor in the transmission
housing.
5. Check the connector for rust, dirt, or oil, and clean if
necessary, then connect the connector securely.
6. Install the intake air duct and the air cleaner
assembly.
7. Install the under-hood fuse/relay box with the bolt.
14-236 14-236
ＴＡ０８ＡＥＢＥ１０４１０６３４６１５ＫＢＡＴ１０
Output Shaft (Countershaft) Speed
Sensor Replacement
1. Remove the bolts securing the under-hood fuse/
relay box, and swing it out of the way.
2. Remove the intake air duct and the air cleaner
assembly.
3. Disconnect the output shaft (countershaft) speed
sensor connector, and remove the output shaft
(countershaft) speed sensor (A).
6 x 1.0 mm
12 N·m
(1.2 kgf·m,
6 x 1.0 mm
8.7 lbf·ft)
12 N·m
(1.2 kgf·m, 8.7 lbf·ft)
A
B
C
B
4. Install a new O-ring (B) on a new output shaft
(countershaft) speed sensor with the speed sensor
washer (C), then install the output shaft
(countershaft) speed sensor in the transmission
housing.
5. Check the connector for rust, dirt, or oil, and clean if
necessary, then connect the connector securely.
6. Install the intake air duct and the air cleaner
assembly.
7. Install the under-hood fuse/relay box with the bolt.
ＴＡ０８ＡＥＢＥ１０４１０６４３８２１ＫＢＡＴ１０
A
＊０１