Honda Accord 2008 Manual page 937

07/11/02 08:47:45 61TA0000_140_0094
Automatic Transmission
DTC Troubleshooting (cont'd)
14. Update the PCM if it does not have the latest
software (see page 11-231), or substitute a known-
good PCM (see page 14-8).
15. Start the engine, and warm it up to normal
operating temperature (the radiator fan comes on).
16. Allow the engine coolant temperature to cool to the
ambient air temperature.
17. Start the engine, and warm it up to normal
operating temperature (the radiator fan comes on),
and wait for at least 20 seconds, then drive the
vehicle at speeds over 19 mph (31 km/h) for at least
5 minutes.
18. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P07 11 indicated?
−
YES Check for poor connections or loose
terminals between the ATF temperature sensor and
the PCM. If the PCM was updated, substitute a
known-good PCM (see page 14-8), then go to step
15. If the PCM was substituted, go to step 1.
−
NO Go to step 19.
19. Monitor the OBD STATUS for P0711 in the DTCs
MENU with the HDS.
Does the HDS indicate PASSED?
−
YES If the PCM was updated, troubleshooting is
complete. If the PCM was substituted, replace the
original PCM (see page 11-232). If any other
Temporary DTCs or DTCs were indicated in step 18,
go to the indicated DTC's troubleshooting.
−
NO If the HDS indicates FAILED, check for poor
connections or loose terminals between the ATF
temperature sensor and the PCM. If the PCM was
updated, substitute a known-good PCM (see page
14-8), then go to step 15. If the PCM was substituted,
go to step 1. If the HDS indicates NOT COMPLETED,
go to step 15.
14-92