Honda Accord 2008 Manual page 955

07/11/02 08:48:08 61TA0000_140_0112
Automatic Transmission
DTC Troubleshooting (cont'd)
18. Turn the ignition switch to LOCK (0).
19. Disconnect PCM connectors B (49P) and C (49P).
20. Check for continuity between output shaft
(countershaft) speed sensor connector terminal
No. 2 and body ground.
＊０４
Is there continuity?
YES
between PCM connector terminal B38 and the
output shaft (countershaft) speed sensor, then go
to step 32.
NO −
14-110
OUTPUT SHAFT (COUNTERSHAFT)
SPEED SENSOR CONNECTOR
NC (BLK/WHT)
Wire side of female terminals
− Repair short to body ground in the wire
Go to step 21.
21. Check for continuity between PCM connector
terminal C14 and output shaft (countershaft) speed
sensor connector terminal No. 3.
OUTPUT SHAFT PCM CONNECTOR C (49P)
(COUNTERSHAFT)
SPEED SENSOR
CONNECTOR
SG1
(GRN/WHT)
Wire side of
female terminals
Is there continuity?
−
YES Go to step 22.
NO − Repair open in the wire between the output
shaft (countershaft) speed sensor connector and
PCM connector terminal C14, then go to step 32.
22. Connect PCM connectors B (49P) and C (49P).
23. Turn the ignition switch to ON (II).
24. Measure the voltage between output shaft
(countershaft) speed sensor connector terminals
No. 2 and No. 3.
OUTPUT SHAFT (COUNTERSHAFT)
SPEED SENSOR CONNECTOR
NC (BLK/WHT)
Wire side of female terminals
Is there about 5 V ?
−
YES Go to step 28.
NO − Go to step 27.
SG1 (GRN/WHT)
Terminal side of
female terminals
SG1 (GRN/WHT)
＊０５
＊０６