Honda Accord 2008 Manual page 1374

07/11/02 09:28:41 61TA0000_180_0041
5. Remove the wheel speed sensor (A) from the
knuckle. Do not disconnect the wheel speed sensor
connector.
＊０８
A
6. Remove the self-locking nut (A) while holding the
joint pin (B) with a hex wrench (C), then disconnect
the stabilizer link (D) from the knuckle, and remove
the brake hose bracket (E).
NOTE: Use a new self-locking nut during
reassembly.
＊０９
E
7. Remove the damper lower mounting bolt (F).
NOTE: Use a new mounting bolt during reassembly.
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
F
12 x 1.25 mm
64 N·m (6.5 kgf·m, 47 lbf·ft)
Replace.
A
10 x 1.25 mm
44 N·m
(4.5 kgf·m,
33 lbf·ft)
Replace.
B
D
8. Remove the control arm mounting self-locking nut
(A) and washer (B).
NOTE: Use a new self-locking nut during
reassembly.
B
A
12 x 1.25 mm
59 N·m
(6.0 kgf·m,
43 lbf·ft)
Replace.
9. Remove the lower arm mounting bolt (A), and the
lower arm B mounting bolt (B), then remove the
knuckle (C).
NOTE: Use new mounting bolts during reassembly.
C
B
12 x 1.25 mm
59 N·m
(6.0 kgf·m,
43 lbf·ft)
Replace.
A
12 x 1.25 mm
C
59 N·m (6.0 kgf·m, 43 lbf·ft)
Replace.
FRONT
(cont'd)
18-41
＊１０
＊１１