Honda Accord 2008 Manual page 1317

07/11/02 09:20:21 61TA0000_170_0051
Power Steering
Steering Gearbox Overhaul (cont'd)
32. Apply vinyl tape (A) to the splines and stepped
portion of the shaft, and coat the surface of the
vinyl tape with power steering fluid.
＊２５
B
Replace.
33. Fit the new O-ring (B) in the groove of the pinion
shaft. Then slide the new valve seal ring (C) over
the shaft and in the groove on the pinion shaft.
34. Remove the vinyl tape, and apply power steering
fluid to the surface of the valve seal ring (A).
＊２６
35. Apply power steering fluid to the inside of the valve
seal ring sizing tool. Set the larger diameter end of
the sizing tool over the valve seal ring, and move
the sizing tool up and down several times to make
the valve seal ring fit in the pinion shaft groove.
36. Remove the sizing tool, turn it over, slide the
smaller diameter end over the valve seal ring.
Move it up and down several times to make the
valve seal ring fits snugly in the pinion shaft groove.
17-50
C
Replace.
07NAG-SR3090A
A
Replace.
37. Apply power steering fluid to the surface of the
sleeve seal ring guide. Slip two new seal rings (A)
over the ring guide from the smaller diameter end,
and expand them. Install only two rings at a time
from each end of the pinion shaft sleeve (B).
A
Note these items when installing the seal ring:
• Do not over-expand the seal ring. Install the resin
seal rings with care so as not to damage them.
After installation, make sure you contract the seal
rings using the sizing tool.
• There are two types of sleeve seal rings; black
and brown. Do not mix the different types of
rings as they are not compatible.
B
38. Align the ring guide with each groove in the sleeve,
and slide a sleeve seal ring into each groove. After
installation, compress the seal rings with your
fingers temporarily.
39. Apply power steering fluid to the seal rings on the
sleeve, and to the entire inside surface of the sleeve
seal ring sizing tool, then slowly insert the sleeve
into the sizing tool.
40. Move the sleeve back and forth several times to
make sure the seal rings fit snugly in the sleeve.
Make sure the seal rings are not twisted.
A
Replace.
07YAG-S2X0100
07ZAG-S5A0100
＊２７
＊２８