Honda Accord 2008 Manual page 1286

07/11/02 09:19:12 61TA0000_170_0020
12. Attach a hose (A) to the end of the pressure control
valve (B) as shown. Then submerge the pressure
control valve in a container of power steering fluid
(C), and apply compressed air in the hose.
• If air bubbles leak through the valve at less than
98 kPa (1.0 kgf/cm , 14.2 psi), replace the pump
as an assembly. The pressure control valve is not
available separately.
• If the pressure control valve is OK, set it aside for
reassembly later.
＊０４
2
A
C
B
Reassembly
13. Install the new pump seal (A) (with its grooved side
facing in) into the pump housing (B) by hand, then
drive it in using the driver and attachment until the
pump seal is flush with the pump housing, and the
seal is fully seated in the pump housing.
07746-0010100
A
Replace.
B
14. Install the shaft comp. into the pump housing.
15. Coat the new O-ring (A) with power steering fluid,
and install it into the groove in the pump housing
(B).
B
07749-0010000
A
Replace.
(cont'd)
17-19
＊０５
＊０６