Transmission Installation - Honda Accord 2008 Manual

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:18:49 61TA0000_140_0257

Transmission Installation

Special Tools Required

• Engine hanger adapter VSB02C000015

• Engine support hanger, A and Reds AAR-T1256

• Front subframe adapter VSB02C000016

• Frame positioning guide pin 070AG-SJAA10S

These special tools are available through the Honda

Tool and Equipment Program 1-888-424-6857.

NOTE: Use fender covers to avoid damaging painted

1. If you did not clean the ATF cooler when you

removed the transmission, and you are installing

an overhauled or remanufactured transmission,

clean the ATF cooler (see page 14-270).

2. Install a new O-ring (A) on the torque converter (B),

then install the torque converter on the mainshaft

3. Install the 14 x 20 mm dowel pins (D) in the torque

converter housing.

4. Place the transmission on a jack, and raise the

transmission to the engine level, then fit the

transmission to the engine.

5. Install the rear transmission housing mounting

12 x 1.25 mm

64 N·m (6.5 kgf·m, 47 lbf·ft)

6. Install the crankshaft position (CKP) sensor cover.

ＴＡ０８ＡＥＢＥ１０４１０４０００００ＫＣＡＴ００

12 N·m (1.2 kgf·m, 8.7 lbf·ft)

Table of Contents