Honda Accord 2008 Manual page 933

07/11/02 08:47:45 61TA0000_140_0090
Automatic Transmission
DTC Troubleshooting (cont'd)
16. Clear the DTC with the HDS.
17. Start the engine, disable the VSA by pressing the
VSA OFF switch, run the vehicle with the shift lever
in D until the vehicle speed reaches 25 mph
(40 km/h), then slow down and stop the wheels.
18. Monitor the OBD STATUS for P0706 in the DTCs
MENU with the HDS.
Does the HDS indicate F AILED?
YES
−
NO
failure, the system is OK at this time. Check for
poor connections or loose terminals between the
transmission range switch and the PCM. If the HDS
indicates NOT COMPLETED, go to step 17.
19. Turn the ignition switch to LOCK (0).
20. Disconnect the transmission range switch
connector.
21. Check for continuity between transmission range
switch connector terminal No. 10 and body ground.
＊０１
TRANSMISSION RANGE SWITCH CONNECTOR
Is there continuity?
YES
NO −
range switch connector terminal No. 10 and ground
(G101), or repair poor ground (G101), then go to
step 27.
14-88
− Go to step 19.
If the HDS indicates PASSED, intermittent
GND (BLK)
Wire side of female terminals
−
Go to step 22.
Repair open in the wire between transmission
22. Turn the ignition switch to ON (II).
23. Measure the voltage between transmission range
switch connector terminals No. 5 and No. 10.
TRANSMISSION RANGE SWITCH CONNECTOR
ATP FWD (YEL/RED)
GND (BLK)
Wire side of female terminals
Is there battery voltage?
−
YES Go to step 24.
NO − Repair open in the wire between the
transmission range switch and PCM connector
terminal B29, then go to step 27.
24. Measure the voltage between transmission range
switch connector terminals No. 8 and No. 10.
TRANSMISSION RANGE SWITCH CONNECTOR
ATP D (PNK)
Wire side of female terminals
Is there battery voltage?
YES − Go to step 25.
NO − Repair open in the wire between the
transmission range switch and PCM connector
terminal B22, then go to step 27.
GND (BLK)
＊０２
＊０３