Honda Accord 2008 Manual page 1524

07/11/02 09:36:24 61TA0000_190_0103
9. Check the BRAKE FLUID LEVEL SWITCH in the VSA
DATA LIST with the HDS.
Does the HDS indicate the BRAK E F LUID LEV EL
SW IT CH as OF F ?
YES − Substitute a known-good gauge control
module, then go to step 1 and recheck. If no DTCs
are indicated, replace the original gauge control
module (see page 22-332).
NO − Go to step 10.
10. Disconnect the brake fluid level switch 2P
connector, then check the BRAKE FLUID LEVEL
SWITCH in the VSA DATA LIST.
Does the HDS indicate OF F ?
Replace the brake fluid master cylinder (the
YES −
brake fluid level switch is included) (see page
19-25).
NO − Go to step 11.
11. Disconnect the gauge control module 32P
connector.
12. Check for continuity between brake fluid level
switch 2P connector terminal No. 2 and body
ground.
BRAKE FLUID LEVEL SWITCH 2P CONNECTOR
Wire side of female terminals
Is there continuity?
−
YES Repair short to body ground in the wire
between the gauge control module and the brake
fluid level switch.
NO − Substitute a known-good gauge control
module, then go to step 1 and recheck. If no DTCs
are indicated, replace the original gauge control
module (see page 22-332).
GRN
(cont'd)
19-103
＊０１