Carrier Bearing Replacement; Differential Carrier And Final Driven Gear Replacement - Honda Accord 2008 Manual

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:24:11 61TA0000_140_0389

Carrier Bearing Replacement

Special Tools Required

Attachment, 40 x 50 mm 07LAD-PW50601

• The bearing and the bearing outer race should be

replaced as a set.

• Inspect and adjust the carrier bearing preload

whenever bearing is replaced.

• Check the bearing for wear and rough rotation. If the

bearing is OK, removal is not necessary.

1. Remove the carrier bearing (A) using a

commercially available puller (B), a bearing

separator (C), and a shaft protector (D).

2. Install new carrier bearings using the 40 x 50 mm

attachment with the small end and a press until it

bottoms. Press the carrier bearing on securely so

there is no clearance between the carrier bearing

and the differential carrier.

ＴＡ０８ＡＥＢＥ１０４１１６１９６１１ＫＢＡＴ００

Differential Carrier and Final Driven

Gear Replacement

1. Remove the final driven gear (A) from the

differential carrier (B).

NOTE: Differential carrier bolts have left-hand

2. Install the final driven gear in the direction shown

on the differential carrier.

3. Secure the final drive gear and the differential

carrier with the bolts. Tighten the bolts to the

specified torque in a crisscross pattern in at least

07LAD-PW50601

ＴＡ０８ＡＥＢＥ１０４１１６１９６２１ＫＢＡＴ１０

(10.3 kgf·m, 74.5 lbf·ft)

Table of Contents