Honda Accord 2008 Manual page 945

07/11/02 08:48:06 61TA0000_140_0102
Automatic Transmission
DTC Troubleshooting (cont'd)
18. Turn the ignition switch to LOCK (0).
19. Disconnect PCM connector B (49P).
20. Check for continuity between input shaft
(mainshaft) speed sensor connector terminal No. 2
and body ground.
＊０４
Is there continuity?
YES
between PCM connector terminal B18 and the input
shaft (mainshaft) speed sensor, then go to step 32.
NO −
14-100
INPUT SHAFT (MAINSHAFT)
SPEED SENSOR CONNECTOR
NM (WHT/RED)
Wire side of female terminals
− Repair short to body ground in the wire
Go to step 21.
21. Check for continuity between PCM connector
terminal B34 and input shaft (mainshaft) speed
sensor connector terminal No. 3.
PCM CONNECTOR B (49P)
SG2
(GRN/BLK)
Terminal side of
female terminals
Is there continuity?
−
YES Go to step 22.
NO − Repair open in the wire between PCM
connector terminal B34 and the input shaft
(mainshaft) speed sensor, then go to step 32.
INPUT SHAFT
(MAINSHAFT)
SPEED SENSOR
CONNECTOR
SG2
(GRN/BLK)
Wire side of
female terminals
＊０５