Honda Accord 2008 Manual page 1347

07/11/02 09:27:33 61TA0000_180_0014
Front Suspension
Knuckle/Hub/Wheel Bearing Replacement (cont'd)
Special Tools Required
• Ball joint remover, 28 mm 07MAC-SL0A202
• Hub dis/assembly tool, 42 mm 07GAF-SD4A100
• Bearing driver attachment, 72 x 75 mm 07746-0010600
• Driver handle, 15 x 135 L 07749-0010000
• Bearing driver attachment, 78 x 90 mm
07GAD-SD40101
• Support base, 73 x 78/82.6 mm 07965-SD90100
Knuckle/Hub Replacement
1. Raise the front of the vehicle, and support it with
safety stands in the proper locations (see page 1-9).
2. Remove the wheel nuts and the front wheel.
＊０２
18-14
3. Remove the brake hose bracket mounting bolt (A).
B
12 x 1.25 mm
108 N·m
(11.0 kgf·m, 79.6 lbf·ft)
4. Remove the brake caliper bracket mounting bolts
(B), then remove the caliper assembly (C) from the
knuckle. To prevent damage to the caliper
assembly or brake hose, use a short piece of wire
to hang the caliper assembly from the
undercarriage. Do not twist the brake hose
excessively.
5. Remove the wheel speed sensor harness bracket
(A) and the wheel speed sensor (B) from the
knuckle. Do not disconnect the wheel speed sensor
108 N·m
connector.
(11.0 kgf·m,
79.6 lbf·ft)
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
＊０３
A
8 x 1.25 mm
22 N·m
(2.2 kgf·m,
16 lbf·ft)
C
＊０４
A
B