Pressure Test - Honda Accord 2008 Manual

07/11/02 09:17:37 61TA0000_140_0220
Automatic Transmission

Pressure Test

Special Tools Required
• A/T oil pressure gauge set w/panel
07406-0020400 or 07406-0020401
• A/T pressure hose, 2,210 mm 07MAJ-PY4011A
• A/T pressure hose adapter 07MAJ-PY40120
NOTE:
• Disable the VSA (if equipped) by pressing the VSA
OFF switch.
• VSA DTC(s) may come on during the test-drive. If the
VSA DTC(s) come on, clear the DTC(s) with the HDS.
1. Make sure the transmission fluid is filled to the
proper level (see page 14-241).
2. Raise the vehicle up on a lift, or apply the parking
brake, block the rear wheels, and raise the front of
the vehicle. Make sure it is securely supported.
3. Allow the front wheels to rotate freely.
4. Remove the splash shield.
5. Connect the HDS to the DLC (A) located under the
driver's side of the dashboard.
＊０１
6. Turn the ignition switch to ON (II). Make sure the
HDS communicates with the PCM. If it does not, go
to the DLC circuit troubleshooting (see page
11-208).
14-218
A
7. Connect the A/T oil pressure gauge to the line
pressure inspection port (A). Do not allow dust or
other foreign particles to enter the port while
connecting the gauge.
A/T OIL PRESSURE
GAUGE SET W/PANEL
07406-0020400 or
07406-0020401
A/T PRESSURE
HOSE, 2,210 mm
07MAJ-PY4011A
(3 required)
8. Start the engine, and warm it up to normal
operating temperature (the radiator fan comes on).
9. Hold the engine speed at 2,000 rpm with the shift
lever in P or N.
10. Measure the line pressure at the line pressure
inspection port (A).
NOTE: Higher pressure may be indicated if
measurements are made in shift lever positions
other than P or N.
Pressure Fluid Pressure
Standard
−
Line (A) 927 986 kPa
−
(9.45 10.05 kgf/cm ,
−
134 143 psi)
ＴＡ０８ＡＥＢＥ１０４１０８０００００ＦＥＡＴ００
A/T PRESSURE
HOSE ADAPTER
07MAJ-PY40120
(3 required)
A
Service Limit
878 kPa
2 2
(8.95 kgf/cm ,
127 psi)
＊０２