Honda Accord 2008 Manual page 1647

07/11/02 09:30:29 61TA0000_200_0080
Glass
Quarter Glass Replacement (cont'd)
11. Attach the front seal (A), the upper clip (B), the
lower clip (C), and the rear clip (D) with adhesive
tape to the inside face of the quarter glass (E) as
shown. Before installing the front seal, apply
primer to the inside face of the quarter glass.
• Be careful not to touch the glass where adhesive
will be applied.
• Be sure to install the upper clip and rear clip with
their convex portions (F) downward.
• Be sure to install the lower clip with its convex
portion (G) upward.
Clip adhesive tape:
Thickness 1.2 mm (0.047 in.)
Width 10 mm (0.39 in.)
Front seal adhesive tape:
Thickness 0.16 mm (0.006 in.)
Width 3.5 mm (0.14 in.)
＊０６
B
F
17 mm
(0.67 in.)
E
147 mm
(5.79 in.)
20-78
: Apply primer here.
E
36 mm
(1.42 in.)
17 mm
(0.67 in.)
E
G
E
D
49.5 mm
(1.95 in.)
13 mm
(0.51 in.)
F
Inside
17.5 mm
(0.69 in.)
E
Inside
12. Install the quarter glass molding (A).
–1 Hold the molding up on the glass, and fit the
hooks (B) of the molding to the edge of the
glass rear corner first.
–2 From the rear corner to the front, hook the
lower clips (C) and upper clips (D) of the
molding to along the edges of the glass.
–3 Push the molding into place securely.
NOTE:
• Take care not to bend or damage the
molding.
• Be careful not to touch the glass where
adhesive will be applied.
• Be sure the front seal contacts the upper and
lower ends of the molding.
A
A
A
A
20 mm
(0.79 in.)
C
A
E
E
A
B
B
A
D
B
A
A
A
A
B
C
B
＊０７
A
B
B