Honda Accord 2008 Manual page 1714

07/11/02 09:34:12 61TA0000_200_0147
Consoles
Center Console Panel Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014
Available through the American Honda Tool and
Equipment Program; call 888-424-6857
NOTE:
• Put on gloves to protect your hands.
• Take care not to scratch the front seat, the dashboard,
and related parts.
• Use the appropriate tool from the KTC trim tool set to
avoid damage when removing components.
1. M/T model: Lower the shift lever boot (A) to release
the hooks (B) from the boot, then remove the shift
knob (C).
＊０１
C
A
B
2. Remove the center console panel (A).
–1 Open the utility pocket lid (B), the front
accessory socket lid (C), and the console
armrest.
–2 Hold the utility pocket lid and the front
accessory socket lid, and gently pull them up to
detach the front clips (D).
–3 Detach the clips (E) and the hook (F) along the
edge of the panel.
–4 Pry up on the rear corner edges of the console
box trim (G) with the appropriate trim tool to
detach the clips (H), and pull the panel up to
detach the clip (I).
–5 Disconnect the front accessory power socket
connector (J). With seat heater (for some
models): Disconnect the driver's seat heater
switch connector (K) and the front passenger's
seat heater switch connector (L).
–6 M/T model with seat heater: Detach the
harness clip (M) fastening the passenger's seat
heater switch harness from the boot plate (N).
Fastener Locations
D : Clip, 2 E : Clip, 7
B
C
D
E
D
E
E
E
J
E
K
M/T model
N
M
ＴＡ０８Ａ００Ｊ２６２１６５１７２３１ＫＤＡＴ２０
H, I : Clip, 3
A
G
E
E H
H
I
F
L
L
(cont'd)
20-145
＊０２