Honda Accord 2008 Manual page 1522

07/11/02 09:36:23 61TA0000_190_0101
DTC 64-12: Steering Angle Sensor Power
Circuit High Voltage
1. Turn the ignition switch to ON (II).
2. Clear the DTC with the HDS.
3. Turn the ignition switch to LOCK (0), then turn it to
ON (II) again.
4. Check for DTCs with the HDS.
Is DT C 64-12 indicated?
−
YES Go to step 5.
NO − Intermittent failure, the system is OK at this
time. Check for loose terminals between the
steering angle sensor 5P connector and the VSA
modulator-control unit 36P connector. Refer to
intermittent failures troubleshooting (see page
19-47).
5. Turn the ignition switch to LOCK (0).
6. Disconnect the steering angle sensor 5P connector
(see page 19-137).
7. Disconnect the VSA modulator-control unit 36P
connector (see step 3 on page 19-142).
8. Turn the ignition switch to ON (II).
9. Measure the voltage between steering angle
sensor 5P connector terminal No. 5 and body
ground.
STEERING ANGLE SENSOR 5P CONNECTOR
Wire side of female terminals
Is there 0.1 V or more?
YES − Repair short to power in the wire between
the steering angle sensor and the VSA modulator-
control unit.
−
NO Go to step 10.
ＴＡ０８ＡＥ４Ｋ８０１０００Ｒ６４１２ＦＡＡＴ０１
SVCC (ORN)
(cont'd)
19-101
＊０１