Subaru SVX 1992 Manual page 513

AUTOMATIC TRANSMISSION AND DIFFERENTIAL [W4B2] 3- 2
°~o
plate
B3-320
Fig . 187
4) Assemble the manual lever and parking rod to the
inside shaft, and secure with a nut .
Tightening torque :
36 - 42 Nom (3 .7 - 4 .3 kg-m, 27 - 31 ft-Ib)
rig . 100
5) Install the detent manual spring .
Position the spring so that its center is aligned with the
center of the manual plate.
Tightening torque :
5 - 7 Nom (0.5 - 0 .7 kg-m, 3 .6 - 5.1 ft-Ib)
6) Install the lathe cut seal ring and lip seal to the
I.D ./O.D . of the low Et reverse piston . Then install the
piston into the case with a press.
a. Be careful not to tilt the piston when installing .
b. Be careful not to damage the lip seal .
-r ri
n
Long bar
o
o 0 nLlfiil
1 COMPRESSOR
`'(398673600)
0
Q SEAT
- ~_- _ r, ~ ~ o (498627000)
B3-322
Fig. 189
7) Install the one-way clutch inner race .
(1) Using a press, install the thrust needle bearing to
the inner race .
rig. I &v
Use the PULLER ASSY (398527700) when removing.
(2) Install four seal rings .
Apply vaseline to the groove of the inner race and to
the seal ring after installation, so that the seal ring will
not expand .
(3) Place the spring retainer CP on the inner race .
Install the spring to the recessed portion of the
piston . Then tighten eight socket head bolts from the
rear side of the transmission case .
Tightening torque :
23 - 26 N " m (2.3 - 2 .7 kg-m, 17 - 20 ft-Ib)
Be sure to tighten evenly .
139