Subaru SVX 1992 Manual page 719

WHEELS AND AXLES
[W5B0] 4-2
13) Disconnect trailing link from housing .
Fig . 105
14) Disconnect lateral link from housing .
Fig. 106
15) Remove DOJ from rear differential using DRIVE
SHAFT REMOVER (28099PA100) .
Be careful not to damage side bearing retainer. Always
use bolt (shown in Figure 108 .) as supporting point for
REMOVER during removal.
Fig. 107
rig. I ud
16) Remove axle nut and drive shaft . If it is hard to
remove, use REMOVER (926470000) and PLATE (28099
PA110) .
a. Be careful not to damage oil seal lip when removing
drive shafts.
b. Left-DOJ spline end is removed together with cir-
clip . Do not remove circlip (from right DOJ) installed
inside of rear differential .
c. Wrap ground surface of DOJ stem with cloth to
prevent it from scratching .
B : INSTALLATION
1) Replace circlip from left-DOJ splines with new one.
2) Insert BJ into hub splines .
Be careful not to damage inner oil seal lip.
3) Using AXLE SHAFT INSTALLER (922431000) and
ADAPTER (927390000), pull drive shaft into hub .
4) Temporarily tighten axle nut .
5) Using SIDE OIL SEAL PROTECTOR (28099PA090),
install DOJ into differential .
h
\~ X 1 1 ,
\ 1 1 ' _
SIDE OIL SEAL PROTECTOR \
" (2~9 PA090)
C4-152
Fig . 109
35