Subaru SVX 1992 Manual page 125

2-11 [W4A0)
ENGINE AND TRANSMISSION MOUNTING SYSTEM
9) Remove starter ASSY . 11) Set special tools .
(1) Raise the vehicle.
(2) Remove nut which install lower side of starter to
transmission case .
(3) Lower the vehicle.
(4) Disconnect power supply terminal and magnet
coil connector.
(5) Remove bolts which install upper side of starter,
and remove starter ASSY .
I iy .
're_
riy. uv
10) Separate torque converter from drive plate .
(1) Remove service hole plug .
(2) Remove bolts which hold torque converter to
drive plate.
I /y .
JJ
13) Remove ATF level gauge and front differential oil
level gauge.
14) Remove under cover .
(1) Lift up the vehicle .
(2) Remove under cover .
. ly . ;j I
(3) While cranking the engine, remove other bolts.
I iy . .r-#
22
12) Remove bolts which hold right upper side of trans-
mission to engine .