Subaru SVX 1992 Manual page 533

AUTOMATIC TRANSMISSION AND DIFFERENTIAL [wloco) 3- 2
10. High Clutch
F B: INSPECTION
A: DISA SSE MBLY 1) Drive plate facing for wear and damage
2) Snap ring for wear, return spring for setting and
1) Remove the snap ring, and take out the retaining
plate, drive plates, and driven plates .
2) Using the COMPRESSOR (398673600), INSTALLER
(398177700), and PLIERS (399893600), remove the
snap ring and take out the spring retainer CP .
3) Apply compressed air to the clutch drum to remove
the piston .
breakage, and spring retainer for deformation
3) Lathe cut rings (large) (small) for damage
4) Piston check ball for smooth operation
C : ASSEMBLY
Fig . 250
1) Using the same special tools as those used in disas-
sembling, assemble the piston, spring retainer CP, and
snap ring .
2) Install the driven plate (thin), drive plates, driven
plates, and retaining plate in that order. Then attach the
snap ring .
3) Checking operation :
Apply compressed air intermittently to the oil hole, and
check the high clutch for smooth operation .
4) Measuring clearance (Retaining plate selection) .
Standard value:
1 .8 - 2.2 mm (0 .071 - 0.087 in)
Allowable limit: 2.6 mm (0 .102 in)
Before measuring clearance, place the same thickness
of shim on both sides to prevent retaining plate from
tilting.
Available retaining plates
Part No .
Thickness mm (in)
31567AA190 3.6 (0 .142)
31567AA200 3 .8 (0 .150)
31567AA210 4.0 (0 .157)
31567AA220 4.2 (0 .165)
31567AA230 4 .4 (0 .173)
31567AA240 4.6 (0 .181)
31567AA250
4 .8 (0 .189)
31567AA260 5.0 (0 .197)
159