Subaru SVX 1992 Manual page 766

4-3 Iw3CO]
STEERING SY STEM
C: DISASSEMBLY
1) Secure gearbox removed from vehicle in vice using
STAND .
Secure the gearbox ASSY in a vice using the special
tool as shown. Do not attempt to secure it without this
special tool .
rig. ou
2) Disconnect the two pipes in/out from gear box after
removal of pipe clamp .
3) Disconnect pipes A and B from steering body and
control valve housing .
Replace pipes and/or flare nuts if damaged.
Fig. 57
4) Remove tie-rod end and lock nut .
5) Pry off clip from small end of boot, and slide it
toward tie-rod end .
rig. 00
6) Using special tool, remove lock wire from large end
of boot .
WRENCH
(927590000)
Boot
(Small end)
Wire
04-041
Fig. 59
7) Cut and remove the boot .
Boot must be replaced with a new one whenever it is
removed.
Fig. 60
36