Subaru SVX 1992 Manual page 654

4-1 [WlA7] SUSPENSION
2. CAMBER AND CASTER
Inspection
1) Place the wheel to be measured on the turning
radius gauge, and make sure the vehicle is level .
2) Set ADAPTER (927380000) into the center of the
wheel, and then install the alignment gauge .
./ /~ Set ADAPTER .
(92738000)
`` I
Alignment gaugew
V
Turning radius
` \
gau ge
04-463
Fig . 6
Front Rear
Ca mber 0°25'±45' 0°40'±45'
Caster 4°50'± 45' -
Front camber adjustment
1) Loosen two self-locking nuts located at lower front
portion of strut.
a. When adjustment bolt needs to be adjusted, hold
its head with a wrench and turn self-locking nut.
b. Discard old self-locking nut and replace with a new
one.
2) While aligning scale for adjustment bolt (located at
rear of vehicle) with mark on strut bracket, set camber
angle within proper specifications .
Inner
Outer
STRUT
COMPL
Positive Negative
camber camber
Housing
04-596
Fig . 7
Left side Right side
Rotate clockwise
Negative camber is
Positive : Same
increased
Rotate counterclock- Positive camber is
Negative : Same
wise
increased
3) Tighten two self-locking nuts .
Tightening torque :
132 - 172 N"m (13 .5 - 17.5 kg-m, 97.4 - 126.9
ft-Ib)
3 . TOE-IN
Inspection
Measure toe-in using a toe gauge :
Front Rear
I Toe-in mm (in) 0± 3 (0± 0 .12)
When using a toe gauge, make sure to measure as
follows :
To measure toe-in, select one point on tire and move
vehicle forward until the tire rotate exactly 180°.
8