Subaru SVX 1992 Manual page 174

ENGINE
[W3A3] 2-3
(2) Seethe rear side of the camshaft gears, and make
sure that the match marks of the intake camshaft gear
(driven gear) and exhaust camshaft gear (drive gear)
are aligned .
0
C
o Math
I mark
-v
C
J % ~` Match
' mark
I
C2-237
Fig . 48
(3) Install a service bolt to the sub-gear mounting
bolt hole of the intake camshaft gear to secure the
sub-gear and driven gear.
(4) Loosen six bolts on three intake camshaft caps
equally, a little at a time, in the numerical sequence as
illustrated .
Fig . 49
Make sure that, as the bolts are loosened, the clear-
ance between the camshaft journal and the cylinder
head journal bearing increases evenly at three places . If
not, tighten the bolts by reversing the illustrated nu-
merical sequence, and then repeat step (4) above.
(5) Remove the camshaft cap while holding the in-
take camshaft with one hand, and then remove the
camshaft . If it is hard to remove the camshaft, rotate
the exhaust camshaft counterclockwise .
Arrange the camshaft caps in correct order.
(6) Loosen six bolts of three exhaust camshaft caps
equally, a little at a time, in the numerical sequence as
illustrated .
Fig . 50
Make sure that, as the bolts are loosened, the clear-
ance between the camshaft journal and the cylinder
head journal bearing increases evenly at three places. If
not, tighten the bolts by reversing the illustrated nu-
merical sequence, and then repeat step (6) above.
(7) Remove the camshaft cap while holding the ex-
haust camshaft with one hand, and then remove the
camshaft .
Arrange the camshaft caps in correct order.
6) Remove hydraulic lash adjusters .
Arrange the hydraulic lash adjusters in order so that
they can be installed in their original positions .
35