Subaru SVX 1992 Manual page 519

AUTOMATIC TRANSMISSION AND DIFFERENTIAL
[W4B41 3- 2
(2) After correctly installing the gasket to the case
mating surface, carefully install the oil pump housing
ASSY . Be careful to avoid hitting the drive pinion
against the inside of the case .
a. Be careful not to damage the seal ring.
b. Be sure to use a new gasket.
\--Oil pump
"J housing ASSY
o
Gasket
B3-342
Fig . 209
(3) Install both parts with dowel pins aligned.
sure no clearance exists at the mating surface.
Any clearance suggests a damaged seal ring .
(4) Secure the housing with two nuts .
Fig . 211
2) Install the converter case ASSY to the transmission
case ASSY, and secure with six bolts and four nuts .
Tightening torque :
34 - 40 N " m (3 .5 - 4 .1 kg-m, 25 - 30 ft-Ib)
Make When installing, be careful not to damage the con-
verter case bushing and oil seal .
Tightening torque :
38 - 44 Nom (3 .9 - 4.5 kg-m, 28 - 33 ft-Ib)
4. CONTROL VALVE AND OIL PAN
1) Install four accumulators with oil pans facing up-
ward .
Be careful not to confuse the springs and installation
positions.
Accumulator piston (3-4)
Accumulator piston (1-2)
B3-343
Fig . 210
3. CONVERTER CASE AND TRANSMISSION
CASE
1) Apply proper amount of liquid gasket (Three-bond
#1215) to the entire converter case mating surface.
Make sure that the rubber seal and seal pipe are fitted
in position .
Accumulator piston
Accumulator piston (2-3)
B3-345
Fig. 212
Spring spec .
Unit : mm (in)
Accumulator spring Outer diameter Free length
1 - 2 28.5 (1 .122)
44 .5 (1 .752)
2-3 20.5 (0.807)
31 .0 (1 .220)
3-4
17.3 (0.6 81) 43 .7 (1 .720)
N - D 17.8 (0.701) I 36 .5 (1 .437)
2) Install and route the transmission harness .
Be careful not to damage the harness .
3) Install the control valve ASSY .
(1) Set the selector lever in range "2" .
145