Subaru SVX 1992 Manual page 914

BRAKES [T5D2] 4-4
1 . CHECK INPUT SIGNAL OF SENSOR TO ABS
CONTROL UNIT
1) Disconnect connector from ABS control unit . (Refer
to No. T6A1)
2) Raise wheels off ground .
3) Measure voltage between ABS control unit terminals
using a digital circuit tester, (Set in "AC" range) accord-
ing to trouble code .
TROUBLE CODE/Connector it Terminal :
7/(R7) No . 24 - No . 26
8/(R7) No . 7 - No. 9
Specified Voltage :
200 - 300 mV (at "creep" speed of AT model)
4) Disconnect ABS control unit connector and measure
resistance between sensor and ground .
Connector £r Terminal/Specified Resistance:
(R7) No. 26 - Body/1 Mfg min .
(R7) No. 9 - Body/1 Mfg min.
2 . CHECK SENSOR
1) Disconnect sensor connector .
2) Measure resistance between sensor terminals .
TROUBLE CODE/Connector & Terminal :
7/Sensor RH No . 1 - No . 2
8/Sensor LH No . 1 - No . 2
Specified Voltage : 0.8 - 1 .3 k:2
3) Measure resistance between sensor connector ter-
minal and ground .
F-1
S2
-0 C r
(R3)6
(R16
1 2
Sensor side
04-749
Fig. 167
Connector fr Terminal/Specified Resistance :
(R36) No . 1 - Body/1 MSS min.
(R18) No . 1 - Body/1 Mid min.
85