Subaru SVX 1992 Manual page 776

4-3 [W3EO) STEERING SYSTEM
04-600
Fig. 95
(4) Turn adjusting screw so that the entire thread
area is coated with liquid packing .
Apply liquid packing
to at least 1 /3 of
entire perimeter and
rotate adjusting screw
04-051
Fig. 96
a . Apply liquid packing of approximately 1 .5 grams
(0 .053 oz) to adjusting screw thread area.
b. Also turn plug to ensure that its entire contact area
is coated with liquid packing.
Liquid packing:
Three-bond 1102 or equivalent
(6) Tighten adjusting plug to 20 N-m (2 .0 kg-m, 14
ft-Ib) and loosen, then tighten to 5 N-m (0 .5 kg-m, 3 .6
ft-Ib) and loosen, and finally tighten to 5 N-m (0 .5
kg-m, 3 .6 ft-Ib) and loosen 25° .
(7) While holding adjusting plug using a closed
wrench, tighten lock nut using LOCK NUT WRENCH .
Tightening torque :
59 - 74 N"m (6 .0 - 7.5 kg-m, 43 - 54 ft-Ib)
i
i
,.
LOCK NUT WRENCH
(34099PA100)
04-052
Fig . 97
a. Do not allow liquid packing to come in contact with
pressure pad .
b. While rotating input shaft to fully move rack shaft
to the left and right, ensure that rack moves smoothly
without binding, and that rotating torque is constant.
6) Installation of boot
(1) Apply sealant to gearbox housing groove .
Use accessory sealant for boot kit (P/N : 34099PAl10) .
Fig. 98
(2) Position boot large end in groove of gearbox, and
small end in groove of tie-rod CP .
a. Ensure that both ends of boot are properly situated
in grooves.
b. When installing another side boot, secure small end
of boot first and then secure large end to prevent an
increase in gearbox internal pressure.
46