Subaru SVX 1992 Manual page 525

AUTOMATIC TRANSMIS SION AND DIFFERENTIAL
[w6CO1 3- 2
6. Control Valve Body
~ A: DISASSEMBLY
1) Remove the following parts from the upper valve
body .
(1) Solenoid ASSY (shift 1-2-3)
(2) Duty solenoid A (line pressure)
Solenoid ASSY
Duty solenoid
A--,.-
(line pressure)
0
0
0
0
Solenoid-2 (shift)
Solenoid-1 (shift)
Solenoid-3
Ri
(overrunning clutch)
0
0
0
0
0
B3-362
Fig. 227
2) Remove the following parts from the lower valve
body .
(1) Duty solenoid B (lock-up)
(2) ATF temperature sensor
Fig. 228
3) Separate the upper valve body and lower valve
body .
a . Do not lose the nine (9) steel balls contained in the
upper valve body .
b. Do not lose an orifice and a strainer contained in the
lower valve body .
c . Remove the upper-lower valve body tightening
bolts . Then remove two locating bolts . ( XX )
During ordinary servicing, clean the control valve bod-
ies in this condition, without further disassembly .
In the event of a seized clutch or other problem,
disassemble the control valve bodies further, and clean
the component parts .
B : INSPECTION
Make sure that each component is free of harmful
gouges, cuts, or dust .
C: ASSEMBLY
Reverse the disassembly sequence, paying attention to
the following points :
a. Be sure to properly position the steel balls, orifice
and strainer.
151