Subaru SVX 1992 Manual page 976

4-7 [M5FS] AUTOMATIC AIR CONDITIONING SYSTEM
8. SET TEMPERATURE CORRECTION
When heating or cooling the compartment, and if the
occupant does not feel comfortable at the preset tem-
perature, he can then adjust the compartment temper-
ature in three steps depending on the ambient temper-
ature measured by the ambient sensor .
(1) Set to step 4 in the self-diagnosis mode . (Ref. to
T400 .)
(2) Press the UP or DOWN switch to change the
correction .
Switch
operation
Display Ambient temperature correction
0 When ambient temperature is
low, compartment temperature is
increased above the standard
Press UP 10 level .
switch o When ambient temperature is
high, compartment temperature
is decreased below the standard
level.
- 05 Standard (No correction is made)
0 When ambient temperature is
low, compartment temperature is
decreased below the standard
Press DOWN 00 level .
switch 0 When ambient temperature is
high, compartment temperature
is increased above the standard
level .
9. SWITCHING BETWEEN °C AND °F
Switching is made by connecting or disconnecting a
connector .
(Under A pillar lower trim driver side : 1333)
connecting -OF
disconnecting - °C
Fig. 91
When the battery is removed, the correction is set at
the standard status with a display of "05" . Verify the
previous correction in advance with the display show-
ing step 4 in the self-diagnosis mode.
High
E
c
E
`m
a
E
U ~\ . .
`m
u
Standard
m
a
Low Ambient temperature High
C4-451
Fig. 90
42