Subaru SVX 1992 Manual page 599

3-3 [woE0) TRANSMISSION CONTROL SYSTEM
INSTALLATION
Tightening torque :
13 - 23 N"m (1 .3 - 2.3 kg-m, 9 - 17 ft-Ib)
1 ) Mount the selector lever ASSY onto the car body .
2) Tighten the six screws to install the selector lever
ASSY to the car body .
Tightening torque :
4.4 - 7.4 Nom (0.45 - 0.75 kg-rn, 3.3 - 5.4 ft-Ib)
C3-112
Fig. 27
3) Set the location of the selector lever at "N".
4) Set the location of the selector arm of the transmis-
sion at "N".
5) Pass the inner cable through the selector arm pin
and then connect it using a washer and snap pin .
1
Cable
Snap pin
n
i I~ 1l(
Cable clamp Inhibitor switch
C3-108
Fig . 28
6) Attach the outer cable to the transmission case with
the bolts .
7) Insert the thread portion of the other inner cable and
into the connector hole of the selector lever, and fix the
other outer cable end to the bracket.
8) Adjust the inner cable length .
(1) Put connector into contact with nut © .
(2) Return nut © to rotate 1/2 .
(3) Tighten nut 10 .
i
i
2 \
O
C3-124
Fig. 29
9) After completion of fitting, make sure that the selec-
tor lever operates smoothly all across the operating
range.
10) Connect the harnesses and check the following
items.
(1) The engine starts operating when the selector
lever is in position "P", but not in other positions.
(2) The back-up light is lit when the selector lever is
in position "R", but not in other positions.
11) Check selector lever operation .
Stop the engine while checking the operation of the
selector lever.
(1) Check that the selector lever does not move from
"N" to "R" without pushing the grip button .
(2) Check that the selector lever does not move from
"R" to "P" without pushing the grip button .
(3) Check that the selector lever does not move from
"P" to "R" without pushing the grip button .
(4) Check that the selector lever does not move from
"3" to "2" without pushing the grip button .
l
t
R
4 b p
4 1 2
B3-559
Fig. 30
10