Subaru SVX 1992 Manual page 703

WHEELS AND AXLES
[W2B0] 4-2
14) Remove spring pin which secures transmission
spindle to FTJ .
Fig. 46
15) Remove BJ from housing . If it is hard to remove,
use REMOVER (926470000) and , PLATE (28099PA110) .
a . When using REMOVER and LATE, remove caliper
body from housing in advance .
b. Be careful not to damage oil seal lip when removing
drive shaft.
c. When replacing drive shaft, also replace inner oil
seal.
16) Remove drive shaft from housing side .
17) Install in reverse order of removal.
For installation and tightening torque of suspension
parts, refer to 4-1 [C100] .
For installation and tightening torque of brake parts,
refer to 4-4 [C100] .
Be careful not to damage inner oil seal lip .
(1) Using AXLE SHAFT INSTALLER (922431000) and
ADAPTER (927390000), pull drive shaft into place.
a. Make sure O-ring is properly installed on transmis-
sion spindle.
b. Apply a sufficient coat of grease to transmission
spindle splines .
c. Always use new sealer-pack type spring pin.
d. Use a new self-locking nut.
e. Use a new axle nut.
f. Always tighten axle nut before installing wheel on
vehicle. If wheel is installed and comes in contact with
ground when axle nut is loose, wheel bearings may be
damaged.
g. Be sure to tighten axle nut to specified torque. Do
not overtighten it as this may damage wheel bearing .
(2) After tightening axle nut, caulk it securely.
B : DISASSEMBLY
1) Place alignment marks on shaft and outer race .
C4-216
Fig. 47
2) Remove FTJ boot band and boot .
Be careful not to damage boot.
Fig . 48
3) Remove circlip from FTJ outer race using screw-
driver .
Fig. 49
19