Table of Contents
Advertisement
STEERING SYSTEM
[Wmo] 4-3
W SERVICE PROCEDURE
1 . Supplemental Restraint Sys-
tem "Airbag"
Airbag system wiring harness is routed near the steer-
ing system .
a. All Airbag system wiring harness and connectors
are colored yellow . Do not use electrical test equip-
ment on these circuit .
b. Be careful not to damage system wiring harness
when servicing steering system .
2 . Tilt & Telescopic Steering Col-
umn with Memory Function
Fig. 32
A: REMOVAL
1) Disconnect battery earth (-) terminal .
2) Remove airbag module ASSY. (Ref. to [5-5] No.
W 1 B2 .)
a . Turn ignition switch "OFF" and wait 10 minutes
before starting work
b. After removal, store airbag module with pad side
facing upward . Do not put any object on pad .
(1) Remove cap (LH).
(2) Remove cap (RH) .
(3) Disconnect airbag system connector at harness
spool.
(4) Set front tires in straight ahead direction .
(5) Remove both steering wheel covers and remove
bolts securing airbag module ASSY using TORX© bit
T30.
Fig. 33
(6) Turn over airbag module ASSY and disconnect
airbag system connector. (Ref . to [5-5j No . W1 132 .)
(7) Disconnect horn and cruise control connectors .
27
Advertisement
Table of Contents
Troubleshooting
