Subaru SVX 1992 Manual page 786

4-3 [W4C2] STEERING SYSTEM
4) Install retaining ring .
Fig . 134
5) Install valve in such a way that when valve sleeve is
removed, pin groove is engaged properly with pinion
shaft pin . (Align marking .)
a . Wrong alignment will affect symmetric characteris-
tic of valve.
b. Make sure that the machined groove which is not
marked with "x" is properly meshed with pinion shaft.
(See figure below.)
0
Machined groove without "X" mark
Machined groove
O
O O
without "X" mark
Machined groove
without "X" mark
Fig. 135
6) Install spacer and retaining ring .
a. Fit retaining ring properly in groove.
b. Be careful not to scratch input shaft as it can cause
oil to leak.
c. Do not expand retaining ring excessively .
Fig. 136
7) Install Y-packing, back-up washer, dust seal and ball
bearing in valve housing .
(Installation procedure is the same as that for the engine
speed sensing type)
8) Secure input shaft with press and install valve ASSY
in valve housing .
Do not allow spacer to extend beyond brazed end.
Otherwise, pinion cannot be inserted properly .
REMOVER
(927540000)
1 .) ~ I
% 1 V
Ball bearing
Electronically controlled P .S . vehicle
04-075
Fig . 137
Fig . 138
9) Installation of valve ASSY .
Refer to 4-3 [W3E0] STEP 2) .
56