Subaru SVX 1992 Manual page 126

ENGINE AND TRANSMISSION MOUNTING SYSTEM
[w4AO) 2-11
15) Remove exhaust system .
(1) Remove 02 sensor harness from clip .
(2) Remove front exhaust pipes and rear catalyst
converter.
(3) Remove front exhaust cover.
Refer to C.2-9 .
16) Remove propeller shaft .
(1) Remove bolts which install propeller shaft to
companion flange of rear differential .
(2) Remove bolts which hold center bearing to body .
(3) Remove propeller shaft from transmission .
Be sure to plug the opening in the transmission after
removal of propeller shaft.
17) Remove selector cable from selector lever ASSY .
18) Remove selector cable bracket from body .
` 1
,11' l
77, Adjusting nut
( J (__J7 \
Bolt
C3-109
Fig . 55
19) Remove performance rod.
rig. "70
20) Remove front axle shaft from transmission .
(1) Remove ball joint of lower arm from knuckle arm
of housing.
(2) Remove stabilizer link from bracket.
(3) Remove brake hose and ABS sensor harness
from start bracket.
(4) Remove spring pin which holds axle shaft into
front differential drive shaft.
rig. o/
(5) Remove axle shaft from transmission .
Refer to C.4-1 .
21) Disconnect ATF cooler hoses from pipes on trans-
mission side .
rig. ors
Catch ATF into container.
22) Remove nuts which hold lower side of transmission
to engine .
rig. oy
23