Subaru SVX 1992 Manual page 697

WHEELS AND AXLES [W1A0] 4-2
10) Fasten caliper assembly to strut using wire
fig. 19
11) Remove BJ from housing . If it is hard to remove,
use REMOVER (926470000) and PLATE (28099PA110) .
a. Be careful not to damage oil seal lip when removing
drive shaft.
b. When replacing drive shaft, also replace inner oil
seal .
12) Remove disc rotor from hub .
If disc rotor seizes up within hub, drive disc rotor out by
installing an 8-mm bolt in screw hole on the rotor .
13) Remove cotter pin and castle nut which secure
tie-rod end to housing knuckle arm .
14) Using a puller, remove tie rod ball joint from
knuckle arm.
Fig. 21
15) Remove housing assembly .
16) Install in reverse order of removal . For installation
and tightening torque of suspension parts, refer to 4-1
[C1001 .
For installation and tightening torque of brake parts,
refer to 4-4 [C100] .
a. Be careful not to damage inner oil seal lip.
b. Use a new self-locking nut.
c. Use a new axle nut.
d. Always tighten axle nut before installing wheel on
vehicle. If wheel is installed and comes in contact with
ground when axle nut is loose, wheel bearings may be
damaged.
e. Be sure to tighten axle nut to specified torque . Do
not overtighten it as this may damage wheel bearing.
17) After tightening axle nut, caulk it securely .
C4-135
Fig. 20
13