Subaru SVX 1992 Manual page 716

4-2 [W4C0]
WHEELS AND AXLES
6) Remove tone wheel bolts and remove tone wheel
from hub .
7) Using HUB STAND (28099PA080), press hub bolt
out .
Be careful not to hammer hub bolts. This may deform
hub.
C4-348
Fig. 90
C: INSPECTION
Check the removed parts for wear and damage . Ii
defective, replace with a new one .
a. If a bearing is faulty, replace it as the bearing set.
b. Be sure to replace oil seal at every overhaul.
JJJ~
I J.1JJ}
Replace as a set .
B4-596
Fig. 91
D: ASSEMBLY
1) Using HUB STAND (28099PA080), press new hub
bolt into place.
a. Ensure hub bolt closely contacts hub.
b . Use a 12 mm (0.42 in) hole in the HUB STAND
(28099PA080) to prevent hub bolt from tilting during
installation.
HUB STAND
(28099 PA080)
i
C4-349
Fig. 92
2) Remove foreign particles (dust, rust, etc.) from mat-
ing surfaces of hub and tone wheel, and install tone
wheel to hub.
a . Ensure tone wheel closely contacts hub .
b. Be careful not to damage tone wheel teeth.
HUBSTAND
(28099 PA080)
Tone wheel
C4-350
Fig . 93
3) Clean housing interior completely . Using HOUSING
STAND "REAR" (28099PA060) and BEARING
(927100000), press bearing into housing .
a. Always press outer race when installing bearing.
b. Be careful not to remove plastic lock from inner race
when installing bearing.
c. Charge bearing with new grease when outer race is
not removed.
32