Table of Contents
Advertisement
4-3 [w2AOJ
STEERING SYSTEM
3) Lift vehicle and remove lower and upper bolts from
universal joint ASSY, and then remove universal joint in
the upward direction .
Scribe alignment marks on universal joint ASSY so
that it can be reassembled at the original serration.
I
C4-034
Fig . 34
4) Disconnect connectors for ignition switch, steering
ECU, and combination switch wiring harness under
instrument panel.
5) Remove two nuts and a bolt under instrument panel
securing steering shaft .
Fig. 35
6) Pullout steering shaft ASSY from hole on toe board .
Be sure to remove universal joint before removing
steering shaft ASSY installing bolts when removing
steering shaft ASSY or when lowering it for servicing
of other parts.
28
Advertisement
Table of Contents
Troubleshooting
