Subaru SVX 1992 Manual page 767

STEERING SYSTEM [w3Co] 4-3
hag. 61
8) Set rack so that it protrudes about 40 mm (1 .57 in)
outside. Pry clinched portion of tie-rod lock washer with
standard screwdriver. (both left and right side)
a. Be careful not to scratch rack, since it can cause oil
to leak.
b. Tie-rod lock washer must be replaced with a new
one whenever it is removed.
fig. uz
9) Using special tool, loosen lock nut . Tighten adjusting
screw until it no longer tightens .
\ `WRENCH
~
-ock nut J~Adjusting screw
(34099PA100)
04-046
Fig . 63
10) Using WRENCH [32 mm (1 .26 in) width across flats],
(P/N 34099PA100) or adjustable wrench, remove tie-rod
CP.
a. Check ball joint for free play, and tie-rod for bends ;
replace if necessary .
b. Check dust seals used with tie-rod end ball joint for
damage or deterioration . Replace if necessary.
rig . D4
11) Loosen adjusting screw and remove spring and
sleeve .
Replace spring and/or sleeve if damaged .
12) Removal of valve ASSY
(1) Remove the two bolts securing valve housing
ASSY.
rig . 00
37