Subaru SVX 1992 Manual page 492

3- 2 [w2C2) AUTOMATIC TRANSMISSION AND DIFFERENTIAL
Tightening torque :
23 - 26 N "m (2 .3 - 2.7 kg-m, 17 - 20 ft-Ib)
Install gear select cable .
Tightening torque :
10 - 18 Nom (1 .0 - 1 .8 kg-m, 7 - 13 ft-Ib)
(3) Install vehicle speed sensor 1 .
Tightening torque :
6 - 8 Nom (0.6 - 0.8 kg-m, 4.3 - 5.8 ft-Ib)
Tightening torque :
Crossmember to body
54 - 83 Nom (5.5 - 8.5 kg-m, 40 - 61 ft-Ib)
Crossmember to cushion
13 - 23 N-m (1.3 - 2.3 kg-m, 9 - 17 ft-Ib)
Low and remove transmission jack .
Fig. 111
(5) Install propeller shaft .
Tightening torque :
N-m (kg-m, ft-Ib)
At rear differential :
18-27 (1 .8-2.8, 13-20)
At center bearing:
34-44 (3 .5-4.5, 25-33)
Align marks on propeller shaft and rear differential
coupling .
(6) Install front exhaust pipe
Tightening torque :
N"m (kg-m, ft-Ib)
At engine :
25-34(2.5-3.5, 18-25)
At hanger :
25-34(2.5-3.5, 18-25)
At front and rear connections:
13-23(1 .3-2.3,9-17)
(7) Lower and remove jack.
(8) Connect the following parts :
0 0 2 sensor connector
0 Vehicle speed sensor1 connector
* Multi-connector
(9) Install pitching stopper.
Tightening torque :
N " m (kg-m, ft-Ib)
47 - 67 (4 .8 - 6.8, 35 - 49) (Body side)
44 - 54 (4 .5 - 5.5, 33 - 40) (Engine side)
(10) Replenish ATF and check oil level . Check for
leaks .
118
rig. I v&
(2) Install extension.
Connect connector.
" Tighten 11 bolts.
rig . r r u
(4) Install rear crossmember.
" Tighten bolts.