Subaru SVX 1992 Manual page 182

ENGINE
[w3E2] 2-3
Fluid packing
C2-257
Fig . 73 Fig. 76
(2) Install front camshaft cover. (3) Install cylinder head cover and gasket .
4) Apply a coat of grease to oil seal lips and install oil
(4) Connect blow-by hose .
seal .
7) Install ignition coils .
Use a new oil seal . 8) Install cam angle sensor .
Fig. 74
5) Install camshaft plug .
c
o
~) ; t ~~>>
CAMSHAFT PLUG ^
INSTALLER I,
(49803 7100)
C2-259
Fig . 75
6) Installation of cylinder head cover
(1) Completely remove excess fluid packing from
location (& in the figure .
(2) Apply soapy water over ® and ® shown in the
figure .
2. CAMSHAFT RH
Operation precautions are the same as those for the LH
camshafts, except the method of aligning the camshaft
gear match marks.
1) Installation of exhaust camshaft
(1) Apply a coat of engine oil to the hydraulic lash
adjuster surface and insert hydraulic lash adjusters .
(2) Apply a coat of engine oil to the camshaft jour-
nals .
(3) Set the exhaust camshaft on the cylinder head
with the front end notch of the camshaft facing
directly downward . Then attach three camshaft caps
to the correct positions, and fully hand- tighten the
cap bolts.
Hold the camshaft with one hand so that it will not
drop while tightening the camshaft caps .
(4) Tighten six bolts on three exhaust camshaft caps
equally, a little at a time, in the numerical sequence as
illustrated .
Fig. 77
43