Subaru SVX 1992 Manual page 768

4-3 [W3CO) STEERING SYSTEM
(2) Remove valve housing ASSY, pinion and valve a . Block pipe connection of steering body ASSY to
ASSY as a unit.
prevent fluid from flowing out.
Extract input shaft when removing valve ASSY.
b. Do not allow rackto come in contact with inner wall
f I' d O h I' d II b h d
C4-0581
o cy in er. t erwise, cy m e, we may e scra %, e ,
resulting in oil leaks.
c. Remove holder ASSY and rack ASSY as a unit.
d. Check rack and steering body ASSY for bends or
cracks ; replace as required .
15) Removal of high-pressure seal
Insert REMOVER from valve side, and lightly tap it using
a hammer to drive out back-up ring and oil seal .
Discard back-up ring and oil seal after removal ; replace
with new ones.
REMOVER
(927580000)
Fig . 66
13) Removal of snap ring from seal holder ASSY
While attaching small screwdriver blade to snap ring via
groove on boot (on cylinder side of steering body
ASSY), push the snap ring using another screwdriver .
Screw driver
!l ~l
I
ill ,i
i
'
` Snap ring
I
I I
//
134-059
Fig . 67
14) Removal of rack ASSY
Push rack out of steering body ASSY while pushing it on
valve side.
rig. ors
>" 1111111110.
c4-289
Fig . 69
16) Removal of oil seal and O-ring
Rack bushing
Holder ASSY
O-ring J
Oil seal
C4-290
Fig. 70
38