Subaru SVX 1992 Manual page 881

BRAKES [WSEOI 4-4
2. ASSEMBLING OPERATION
1) Assembling piston CP :
Apply recommended brake fluid to inside wall of cylin-
der, and to outer surface of piston CP, and install piston
CPs carefully into cylinder.
2) Assembling supply valve stopper :
After installing piston into cylinder, push primary piston
in about 10 mm (0.39 in), using a rod, such as push rod
then assemble gasket and supply valve stopper.
Tightening torque :
1 .5 - 2.9 N"m (0 .15 - 0.3 kg-m, 1.1 - 2.2 ft-Ib)
If the gasket and secondary piston stopper are assem-
bled without pushing in the primary piston, scratches
may be caused on the secondary piston, and no pres-
sure may be built up in the secondary side . To avoid
such an error, be sure to push in the primary piston
before assembling these parts.
3) Assembling C-ring :
With primary piston pushed in slightly, attach C-ring by
using C-ring pliers .
After assembling, ensure that the C-ring is fitted se-
curely in the ring groove.
E: INSTALLATION
Installation is in the reverse order of removal .
After installing master cylinder, bleed air from the
brake system .
Be sure to use recommended brake fluid .
51