Subaru SVX 1992 Manual page 624

3-4 [W2A2]
AWD SYSTEM
(6) Remove the bolts which secure the front and rear
9) Secure rear drive shaft to rear sub frame using wire.
-)'-(
Rear sub frange
C ' Wire
Spline shaft -
Rear drive shaft
C3-151
Fig. 36
Fig. 33
The LH side spline shaft circlip only comes out together
(7) Remove the DOJ from the rear differential by
with the shaft. RH side circlip is fitted inside the rear
using the DRIVE SHAFT REMOVER .
differential, and it need not be removed .
Special tool:
10) Remove the side oil seal .
DRIVE SHAFT REMOVER (28099PA100)
PULLER ASSY (398527700)
t3
c,:
i
83-153
Fig . 35
Fig. 37
11) Drive in a new side oil seal with DRIFT.
Apply chassis grease between the oil seal lips .
Special tool :
DRIFT (398437700)
12) Insert the DOJ into rear differential .
Before inserting, replace the circlip at the end of the LH
spline shaft with a new one.
For replace of circlip, refer to "4-2 WHEEL AND AXLES.
(1) Install the side oil seal protector to rear differen-
tial .
18
When removing DOJ from rear differential using re-
mover, fit remover to the bolt as shown in Fig. 35 so as