Subaru SVX 1992 Manual page 486

Hide thumbs Also See for SVX 1992:

Table of Contents

AUTOMATIC TRANSMISSION AND DIFFERENTIAL

also monitors the input signal electronically controlled

for each range and turns on the corresponding range

light on the instrument panel.

When light operation, driving condition or starter motor

operation is erroneous, first check the shift linkage for

improper operation . If the shift linkage is functioning

properly, check the inhibitor switch .

(Inspection)

(1) Disconnect cable end from selector lever .

(2) Disconnect inhibitor switch connector .

(3) Check continuity in inhibitor switch circuits with

selector lever moved to each position .

points, adjust the inhibitor switch .

Br LgY YW YB LgR WL BW BY

Signal sent to AT control unit

Also check that continuity in ignition circuit does not

exist when selector lever is in R, 3, 2 and 1 ranges.

(4) Check if there is continuity at equal points when

the selector lever is turned 1 .5° in both directions

from the N range .

If there is continuity in one direction and the continu-

ity in the other or if there is continuity at unequal

(Adjustment)

(1) Loosen the three inhibitor switch securing bolts .

(2) Shift the selector lever to the N range .

(3) Insert STOPPER PIN (499267300) as vertical as

possible into the holes in the inhibitor switch lever

and switch body .

(4) Tighten the three inhibitor switch bolts .

Tightening torque :

(0 .3 - 0 .4 kg-m, 2 .2 - 2 .9 ft-Ib)

~ J . l~ \ 1

(5) Repeat the above checks . If the inhibitor switch is

determined to be "faulty", replace it .

3. SENSOR (in transmission)

1) Check each sensor, solenoid and ground system for

short circuits .

Troubleshooting