Table of Contents
Advertisement
4-3 [w5B0)
STEERING SYSTEM
B: CHECK
Check all disassembled parts for wear, damage or other
abnormalities . Repair or replace faulty parts as required .
Part name
Inspection
Remedy
Pipe
* O-ring fitting surface
for damage
Nut for damage
Replace with new one .
Pipe for damage
Clamp
0 Clamps for weak
Replace with new one .
clamping force
Hose
0 Flared surface for
damage
Flare nut for damage
Outer surface for
cracks
Outer surface for wear
Replace with new one .
Clip for damage
End coupling or
adapter for degrada-
tion
C: ASSEMBLY
Assembly is in the reverse order of removal .
6. Oil Pump & Reservoir Tank
A: REMOVAL
1) Disconnect battery earth (-) terminal
2) Remove belt cover.
3) Loosen nuts which secure idler pulley .
4) Loosen slider bolt, and remove V-belt .
rig. 14z
5) Remove nut from front end of oil pump pulley, and
detach oil pump pulley.
Fig. 143
6) Disconnect oil pump switch harness connector .
7) Drain approximately 0.3 liters (0.3 US qt, 0.3 Imp qt)
of fluid from oil reservoir tank.
tag . 144
8) Disconnect hose from oil reservoir tank.
a . Be careful not to spill fluid from hose end to V-belt.
b. Cover open ends of hose and pipe with a clean cloth
to prevent entry of foreign matter .
9) Disconnect pressure pipe from pump .
Fig. 145
10) Remove bolts securing oil pump Et tank to bracket,
and then remove pump and tank .
58
Advertisement
Table of Contents
Troubleshooting
