Table of Contents
Advertisement
4-4 [T6F11
BRAKES
F: INSPECTION OF COMPONENTS
1 . ABS SENSOR INSTALLATION
1) Dismount brake as outlined in manual to gain access
to speed sensor and tone wheel for inspection .
2) Check pole piece and tone wheel for accumulation of
foreign particles . If necessary, remove foreign particles
and clean .
3) Check tone wheel teeth for cracks for deformities . If
necessary, replace tone wheel (No . of teeth : 44) with a
new one .
4) Check tone wheel for looseness .
84-543
Fig . 173
Tightening torque :
10 - 16 N"m (1 - 1.6 kg-m, 7 - 12 ft-Ib)
5) Measure tone wheel-to-pole piece gap over entire
perimeter of the wheel.
84-542
Fig. 172
Front wheel
Rear wheel
Specifications
0 .7 - 1 .0 mm
(0 .028 - 0 .039 in)
0.5 - 1 .0 mm
(0 .020 - 0 .039 in)
Specifications
0 .05 mm (0 .0020 in)
7) For inspection procedures of sensors, refer to'Trou-
ble Codes 5, 6, 7 and 8" .
If measurements check out "Not OK", adjust the gap
using spacers (Part No. 26755AA000) . If spacers cannot
correct the gap, replace worn sensor or worn tone
wheel .
6) Check hub runout.
96
Sensor gap
t
Sensor gap
Advertisement
Table of Contents
Troubleshooting
